Peugeot 308 Key Fob Problems and How to Fix Them
If your Peugeot 308 key fob stopped functioning one day, it could be due to a dead coin battery or water damage, receiver module issues or a faulty electronic chip. These are all simple fixes that can bring your car back to speed in a matter of minutes!
The key blade may become worn-out and cause an unusable car key. You can fix the issue by visiting your local Car Key Man Auto Locksmith to install a new blade.
Battery
The key fob battery in your Peugeot 308 can sometimes die or become weak enough to send an energizing signal to the car. The key fob may cease to function and stop you from locking or unlocking your doors or even starting the engine. You'll need a new battery on your key fob to correct this.
You'll have to purchase a new battery from an auto parts shop or your local hardware store. Make sure that the battery is brand new and not sat on the counter for too long. A new battery will have more capacity and will be able to send a stronger signal to the car.
After replacing the battery, try unlocking the doors and locking them with the key fob. If the doors do not unlock it's possible that the receiver module inside the car is the culprit. Your local Peugeot dealer can reprogram the receiver module.
The internal chip of the key fob can also be damaged. It's possible to cause damage to your key fob if you drop it on the ground, or expose it to moisture. Rubber seals that protect your chip from moisture might wear out over time. This is especially the case if you expose your key fob to water over long periods of time, like submerging it at the beach in the ocean. To avoid this, you should keep your key fob away of water and out of water.
Water Damage
If your key fob becomes wet, whether you dropped it into the pool or threw it into a puddle, don't assume it's a loss. The key fob is protected by rubber seals however, prolonged exposure to water may affect the electronic chip. Water is a great conductor and any water that is absorbed into the key fob will cause short circuits in series that eventually destroy the electronic chip. After removing the battery scrub its contacts with isopropyl ethanol and dry it completely before putting it back in.
Your Peugeot 308 may not start because of an unresponsive battery. If you have an extra car, jumper cables could be used to start the engine again. If the battery is defective the battery must be replaced.
A bad receiver in the car can also prevent it from receiving the signal from the key fob. The key fob may be damaged, or there could be a problem with the antenna, wiring or the key fob itself. If you're using a new key fob, it may need to be programmed for the vehicle. If you're not able to solve the issue, you should contact an expert technician. A skilled technician will be able to diagnose the problem quickly and fix it promptly.
Radio Interference
Signs like key fobs that are not recognized or having a restricted range typically indicate that there is a problem in the system. This can be either radiated, or conducted, with the latter being caused by power supply cables or speaker wiring that is too close to electrical components. Generally, rerouting the cables or moving them further away from these components can solve the issue.
It's unlikely that someone is watching the key fob's signal in attempt to steal your car It's possible, however, that radio interference has slowed the signal. Fortunately, this is easy to fix.
If your key fob is not being recognized by the system, try replacing the battery. Make sure the battery is of the correct size and type. Incorrectly sized batteries can damage the fob.
Some aftermarket alarm systems and radar detectors use the same radio frequency as your key fob and can cause them to interfere with your key signals. Beware of attaching these devices to your key fob.
Pairing Issues
The remote keyless entry system in a car has an antenna that receives radio frequencies from the key fob. It is not possible to start your vehicle if the receiver is not functioning properly, even if your key fob works and is reprogrammable. The issue could be caused by a number of reasons, such as a dead coin battery and water damage. The receiver could be malfunctioning because of an error in the software or internal damage to the key itself.
The battery inside your Peugeot 308 keyfob may have been drained. please click the following internet page can be replaced, but ensure that it's the correct battery for your keyfob. It is best to choose an item that has the same size in terms of voltage, size, and specifications as the original.
Another reason that the reason why your Peugeot 308 key fob might not be working is due to the fact that it has been paired to an unrelated vehicle. This could be the case if you have given your key fob to a friend or when the key has been used to unlock and start other vehicles. This issue can be solved by reprogramming your key fob using an OBDII scan. This tool will ask for information about your vehicle, for example, its VIN or engine type. It is crucial that you enter the correct information.